Page 2 of 2
Re: Custom Cold Air Intake for the Fofo!
Posted: Sun Aug 12, 2007 11:36 am
by Farmer
Deagle50ae wrote:I Used
2 - 90* bends
1 - 45* bend
4 - 3" silicone couplers
8 - 3" t-bolt clamps
as for tools (this is all I used)
flathead screwdriver
1/4" socket set (for t-clamps)
sawzall (for cutting pipe, an exhaust cutting kit works well too)
dremel tool (to round out the sharp edges and clean up any debris)
small Pliers
If you guys are interested, I will be dismantling the intake tomorrow, I can take pictures of the "exploded" (dismantled) setup. It's really VERY easy. I never understood why anybody spent HUNDREDS of dollars on a filter and a couple pipes.
That would be great and i have a buddy that can make the 90's and 45's for us cheap, The 3" silicone couplers and clamps I have at work.
-Miles
Re: Custom Cold Air Intake for the Fofo!
Posted: Sun Aug 12, 2007 1:02 pm
by Deagle50ae
that would be cool. I think... PERHAPS, MNFocus should manufacture it's own CAI for sale to benefit the club!
Re: Custom Cold Air Intake for the Fofo!
Posted: Mon Aug 13, 2007 4:51 pm
by 5doorfury
I agree! That is an AWESOME idea! That can also end the debate over the never ending "which brand/type intake should I use"...you just say "DUHH, THE MN FOCUS ONE! It's the BEST!!!!"
Re: Custom Cold Air Intake for the Fofo!
Posted: Mon Aug 13, 2007 10:24 pm
by o2designs
NcfParts wrote:Deagle50ae wrote:I Used
2 - 90* bends
1 - 45* bend
4 - 3" silicone couplers
8 - 3" t-bolt clamps
as for tools (this is all I used)
flathead screwdriver
1/4" socket set (for t-clamps)
sawzall (for cutting pipe, an exhaust cutting kit works well too)
dremel tool (to round out the sharp edges and clean up any debris)
small Pliers
If you guys are interested, I will be dismantling the intake tomorrow, I can take pictures of the "exploded" (dismantled) setup. It's really VERY easy. I never understood why anybody spent HUNDREDS of dollars on a filter and a couple pipes.
That would be great and i have a buddy that can make the 90's and 45's for us cheap, The 3" silicone couplers and clamps I have at work.
-Miles
Can he make a foot long pipe with a really short 90 at the end? Please let me know how much that would be.
Re: Custom Cold Air Intake for the Fofo!
Posted: Mon Aug 13, 2007 10:25 pm
by o2designs
I'll make the vinyl for the intake tubes if you guys want to make em for dist.