Page 1 of 1
So My plan is in motion
Posted: Sat Nov 18, 2006 2:01 am
by umdivx
got most of the parts:
http://homepage.duluthmn.com/~umdivx/Turbo%20Stuff/
Paid in full to Korri. Then also sold off a bunch of shit on Ebay (closet spring cleaning) after said and done my pay pal account has a balance of damn near $800, plus I still have more shit to sell.
So anyways I'll be piecing this all together after the holidays. I figure I'll slowly do it over a week or two span and get it tuned after that. So wish me luck!
- Jsoh
Posted: Sat Nov 18, 2006 10:03 am
by mars
GOOOOOD LUCK!!!! hope to see the finished setup josh!!!
Posted: Sun Nov 19, 2006 6:12 pm
by sc0tty8
Buy both boost and AFR gauges.
If you want any of the parts coated, I can ask someone at work that knows something, apparently they do power, dip, spray and a few other types of coatings, and it would prob cost a case of beer to do, they also do phos(phosphates) and blasting. Phos is the chemical way of cleaning it. I talked to one guy, I will prob have him do a set of heads for me and get my plenum coated
I need to find out if they do any type of a ceramic coating.
Posted: Sun Nov 19, 2006 6:15 pm
by umdivx
sc0tty8 wrote:
Buy both boost and AFR gauges.
If you want any of the parts coated, I can ask someone at work that knows something, apparently they do power, dip, spray and a few other types of coatings, and it would prob cost a case of beer to do, they also do phos(phosphates) and blasting. Phos is the chemical way of cleaning it. I talked to one guy, I will prob have him do a set of heads for me and get my plenum coated
I need to find out if they do any type of a ceramic coating.
Already have AFR gauge. and no way in hell i'll buy a wide band since I am not doing my own tuning. I'll just rattle can my charge piping. I don't need to spend a fortune making it look good.
- Josh
Posted: Sun Nov 19, 2006 6:25 pm
by sc0tty8
Case of beer is not a fortune, most of it, I could prob get done for free