Minnesota Focus Owners Club

Here's what I have:
New Garett T-25, 300 zx replacement model, with exhaust elbow in cast
New 42lb FR injectors
New Calibrated MAF for 42lb injectors w/housing
New exhaust manifold bolt set
New copper exhaust manifold gasket
New Focus RS cast turbo manifold

To complete, you would need:
FMIC, piping kit, gaskets, oil/water lines, base tune, tuning, turbo inlet/outlet, air filter, downpipe.
This set up was originally for "project low boost". The wastegate is set for 7psi. I was going to go without an intercooler too.
The exhaust elbow makes the downpipe easy to make.

$775

bump for revisions

updated

oh, I might buy this from you. boosting my focus soon, but I already have a turbo.

how hard to adapt for svt?

Too bad you sold the RS mani, I was seriously thinking about it...

o2designs wrote:Too bad you sold the RS mani, I was seriously thinking about it...

Well, start thinking about it again, cause I now have a brand new RS manifold