Minnesota Focus Owners Club

I'm need to upgrade my exhaust from the 2 1/4' that I have to 3". I looked at some on line (truebendz, borla, magnaflow, etc) but none seem to have the center exit, which I need. Anyone know a good shop on the north side that will put on a good 3" system, from the catless downpipe back? Should I keep the resonator?

Buy just the 3" pipe from trubends and we can mod it for the center exit. Not a problem

You really think so? And what about the welding the hangers to stainless? You thought that may be tough?

KRYPTO wrote:Buy just the 3" pipe from trubends and we can mod it for the center exit. Not a problem

I agree....it'll be way cheaper and hangers are no big deal

ch435 wrote:You really think so? And what about the welding the hangers to stainless? You thought that may be tough?

MMMMMMM Stainless Welding My favorite metal to weld with the TIG welder.

I can do stainless. Not a problem. Are you going to keep the same tip?

When you said shop on the north side.. that really threw me off. I thought you were talking about north minneapolis.

I like the tip, but it's only 2 1/4, wouldn't that defeat the purpose of 3" exhaust everywhere else?

And, by north side, I meant north suburbs, sorry.

Then I think you should do something alittle different. Straight 3" all the way to the rear then put a Supertrapp on

Patalrob wrote:

ch435 wrote:You really think so? And what about the welding the hangers to stainless? You thought that may be tough?

MMMMMMM Stainless Welding My favorite metal to weld with the TIG welder.

i like titainiun.....titneeum......tie tain neeum it is fun to watch it crack and shatter when ran too hot. with any mig set up you can weld a stainlees hanger to most t304 pipe.