Here's what I have:
New Garett T-25, 300 zx replacement model, with exhaust elbow in cast
New 42lb FR injectors
New Calibrated MAF for 42lb injectors w/housing
New exhaust manifold bolt set
New copper exhaust manifold gasket
New Focus RS cast turbo manifold
To complete, you would need:
FMIC, piping kit, gaskets, oil/water lines, base tune, tuning, turbo inlet/outlet, air filter, downpipe.
This set up was originally for "project low boost". The wastegate is set for 7psi. I was going to go without an intercooler too.
The exhaust elbow makes the downpipe easy to make.
$775
Partial Zetec turbo kit *07/19/08*
-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
Last edited by HotRodWagon on Sat Jul 19, 2008 4:02 am, edited 5 times in total.
...always in focus...
...costra nostra tobasco
...costra nostra tobasco
-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
bump for revisions
...always in focus...
...costra nostra tobasco
...costra nostra tobasco
-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
updated
...always in focus...
...costra nostra tobasco
...costra nostra tobasco
wink wink.....bitches-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
Well, start thinking about it again, cause I now have a brand new RS manifoldo2designs wrote:Too bad you sold the RS mani, I was seriously thinking about it...
...always in focus...
...costra nostra tobasco
...costra nostra tobasco