Page 2 of 2
Re: FRPP Borla flexback exhaust fittment issue.
Posted: Mon May 28, 2007 5:58 pm
by Steve@Tasca
It's not an SVT system, It's a Duratec system.
The problem is it's a 2.3 system, Not a 2.0 system.
Go figure, The only Duratec Borla FRPP still carries is for the car that can't be had with the engine the exhaust is designed for.
There is no 2.0 Duratec Borla.
Re: FRPP Borla flexback exhaust fittment issue.
Posted: Mon May 28, 2007 6:18 pm
by Deagle50ae
I stand corrected
Re: FRPP Borla flexback exhaust fittment issue.
Posted: Mon May 28, 2007 8:31 pm
by zurno
FORDSVTPARTS wrote:
It's not an SVT system, It's a Duratec system.
The problem is it's a 2.3 system, Not a 2.0 system.
Go figure, The only Duratec Borla FRPP still carries is for the car that can't be had with the engine the exhaust is designed for.
There is no 2.0 Duratec Borla.
wouldn't it technically be for a 2003-2004 PZEV Hatchback then?
Re: FRPP Borla flexback exhaust fittment issue.
Posted: Tue May 29, 2007 3:48 am
by 19-Delta
So let me get this straight, if I step up to this after buying my FS Turbo (I have the D23), it will fit perfectly? and come with a resonator? I currently have the 2.25" FS "stealth" exhaust and love the lack of rice noise coming from my rear end.
Thanks,
Tim
Re: FRPP Borla flexback exhaust fittment issue.
Posted: Tue May 29, 2007 2:48 pm
by Deagle50ae
if you turbo your car, the downpipe would have to meet at the same place as the stock flexpipe. other than that, it should be good.
that being said, turbo's hate back pressure. I'd go custom 3" turbo-back exhaust. turbo's change the sound of your exhaust DRAMATICALLY
also, this exhaust has two resonators. it sounds great but it's almost as quiet as stock. I can hardly hear it over the sound of my bad wheels bearing.