Page 1 of 1
header ??????
Posted: Mon Oct 22, 2007 9:35 pm
by soul_hammer
OK so im wondering if the ztec and duratec have the same bolt placement and exhaust port placement. im thinking if they do buy a nice inexpensive header and cuting the down tubes and spining them around then rewelding them.
any one know if it could work or not?
Re: header ??????
Posted: Mon Oct 22, 2007 9:41 pm
by zurno
the duratec and zetecs are ass backwards form eachother
Re: header ??????
Posted: Mon Oct 22, 2007 9:44 pm
by soul_hammer
i know that the intake and exhaust are on the wrong sides but that is why i would cut and flip the down tubes.
Re: header ??????
Posted: Tue Oct 23, 2007 5:41 am
by Steve@Tasca
As far as I know nothing will interchange at all.
Your best bet is to just buy a Duratec header or have one built.
Re: header ??????
Posted: Wed Oct 24, 2007 12:53 am
by soul_hammer
yeah i figured that but the 100 bucks vs 400 was the big thing that made me think of this. damn to bad!
Re: header ??????
Posted: Wed Oct 24, 2007 9:06 pm
by KRYPTO
Go to the parts store and have them grap a header gasket from both to see if they match.
Then you'd have to make sure there is nothing in the way of your install.
Re: header ??????
Posted: Fri Oct 26, 2007 5:20 pm
by soul_hammer
DUHHHH
why the hell didnt i think of that. great idea thanks krypto